as wombat said
| ausmini https://www.ausmini.com/forums/ |
|
| layshaft end float https://www.ausmini.com/forums/viewtopic.php?f=2&t=39292 |
Page 1 of 1 |
| Author: | volkmini [ Sat Feb 16, 2008 11:31 am ] |
| Post subject: | layshaft end float |
hi, i have just measured 0.008" of end float. the book says the maxium is 0.006". should i leave it or put a 0.004" shim inbetween the thrust washer and the housing. |
|
| Author: | Wombat [ Sat Feb 16, 2008 11:39 am ] |
| Post subject: | |
Bring it down to the bottom end of the range |
|
| Author: | BALLISTIC [ Sat Feb 16, 2008 12:32 pm ] |
| Post subject: | |
as wombat said
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|