No just good ol' engine oil. what ever you use normally castrol, penrite fuch's
etc, etc...
| ausmini https://www.ausmini.com/forums/ |
|
| Question on Gearbox rebuild https://www.ausmini.com/forums/viewtopic.php?f=2&t=39433 |
Page 1 of 1 |
| Author: | Wombat [ Wed Feb 20, 2008 11:32 am ] |
| Post subject: | Question on Gearbox rebuild |
If you are rebuilding a gear box that may be sitting a while before being put together with the block and actually run, would you use a heavier oil say gear oil at 90W to lube it all as you put it together ? |
|
| Author: | BALLISTIC [ Wed Feb 20, 2008 11:35 am ] |
| Post subject: | |
No just good ol' engine oil. what ever you use normally castrol, penrite fuch's etc, etc...
|
|
| Author: | TheMiniMan [ Wed Feb 20, 2008 12:02 pm ] |
| Post subject: | |
I actually use "STP" when building gearboxes,,,whether they`re going to sit for a while or not |
|
| Author: | headgasket [ Wed Feb 20, 2008 2:00 pm ] |
| Post subject: | |
n00b question: can the gearbox be rebuilt with the engine in the car? Either way is it costly? Yesterday my 2nd gear lost a lot of its feel... theres not much of a thunk when it goes in, and it only goes in right at the end of the shifter travel. |
|
| Author: | Harley [ Wed Feb 20, 2008 2:29 pm ] |
| Post subject: | |
Gearbox is an engine out job. No two ways about it. |
|
| Author: | Wombat [ Wed Feb 20, 2008 3:44 pm ] |
| Post subject: | |
TheMiniMan wrote: I actually use "STP" when building gearboxes,,,whether they`re going to sit for a while or not
What one? |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|