ausmini
https://www.ausmini.com/forums/

2 into 1 piece
https://www.ausmini.com/forums/viewtopic.php?f=2&t=39441		 Page 1 of 1
Author:  mattsmadmini [ Wed Feb 20, 2008 2:23 pm ]
Post subject:  2 into 1 piece
Hey all just wondering if anywhere sells a 2-to-1 piece for LCB extractors?
Author:  Kennomini [ Wed Feb 20, 2008 4:36 pm ]
Post subject: 
I don't think you can buy the Y piece as a single unit.
If your handy with a mig you can buy the pieces needed to make your own from most exhaust shops (2x90* mandual bends, 1x collector). Just make sure they fit in or over the lcb's.
It is time consuming as you have to tac them together on the car then pull them off and weld them a bit more than refit and check again etc etc but it can be done.
On the note of making the Y piece don't get the exhaust shop to make it because it will end up costing near what a new set of lcb's would cost :roll:
Author:  drmini in aust [ Wed Feb 20, 2008 6:52 pm ]
Post subject: 
You can buy the Maniflow LCB one but when I found out how much, I bought a whole new LCB. :lol:
Minisport SA quoted me $127 + post for the Y piece... :shock:
Author:  Flying Brick [ Thu Feb 21, 2008 6:48 am ]
Post subject: 
I had an exhaust shop make me one a few months ago, $60. Some shops don't like doing little jobs like that, they want to do the whole system with the car, but you may find one that will do it.

Steve.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/