feed a bit of rope down the spark plug hole, I've done it a few times, works well
| ausmini https://www.ausmini.com/forums/ |
|
| Crank pulley..... https://www.ausmini.com/forums/viewtopic.php?f=2&t=40108 |
Page 1 of 1 |
| Author: | Blunder [ Wed Mar 12, 2008 7:25 pm ] |
| Post subject: | Crank pulley..... |
Whats the best wat to remove pulley bolt when engine is out of the car with clutch/flywheel removed??? |
|
| Author: | suffolk [ Wed Mar 12, 2008 7:35 pm ] |
| Post subject: | |
You could stuff a long piece of rag in the spark plug hole to lock her up...But i would just put the flywheel back on with the cover and put a screw diver thru the starter motor hole and lock it up that way to undo the bolt...Cheers!! |
|
| Author: | gafmo [ Wed Mar 12, 2008 7:38 pm ] |
| Post subject: | |
I use a wheel bearing race |
|
| Author: | Blunder [ Wed Mar 12, 2008 7:38 pm ] |
| Post subject: | if only.... |
only got a apart engine, got flywheel but no retaining locator thingy! lol |
|
| Author: | Morris 1100 [ Wed Mar 12, 2008 7:44 pm ] |
| Post subject: | |
Put a socket on the bolt and give the bar a whack with a block of wood. |
|
| Author: | 1071 [ Wed Mar 12, 2008 7:46 pm ] |
| Post subject: | |
I assume the question is because the engine and gearbox are still attached? Otherwise just stick a suitable piece (inch and a half square?) of hardwood between the crank and case. If 1. then maybe a rattle gun? Cheers, Ian |
|
| Author: | simon k [ Wed Mar 12, 2008 7:53 pm ] |
| Post subject: | |
feed a bit of rope down the spark plug hole, I've done it a few times, works well
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|