If I was going that way I'd fit the whole flappy boot lid.
Wouldn't happen though for me, I went the other way (rover lid on early car).
| ausmini https://www.ausmini.com/forums/ |
|
| Rear number plates flap https://www.ausmini.com/forums/viewtopic.php?f=2&t=40473 |
Page 1 of 1 |
| Author: | mini1989 [ Tue Mar 25, 2008 11:41 pm ] |
| Post subject: | Rear number plates flap |
Just wondering can I fit a number plate flap on the boot lid of a 1989 Mini? What other parts do I need? |
|
| Author: | Harley [ Wed Mar 26, 2008 7:30 am ] |
| Post subject: | |
If I was going that way I'd fit the whole flappy boot lid. Wouldn't happen though for me, I went the other way (rover lid on early car).
|
|
| Author: | gafmo [ Wed Mar 26, 2008 10:42 am ] |
| Post subject: | |
I took our one off..what a Pain |
|
| Author: | drmini in aust [ Wed Mar 26, 2008 11:15 am ] |
| Post subject: | |
gafmo wrote: I took our one off..what a Pain
The flap was originally fitted so you could carry stuff with the boot open. I dunno if that's still legal, and even if it is the car will suck exhaust fumes into the cabin when moving, as the rear seat doesn't seal the bootspace off. |
|
| Author: | AEG163job [ Wed Mar 26, 2008 1:43 pm ] |
| Post subject: | |
You'll need the hinges (HYA 7234/7235) & countersunk screws to suit, plus the light & cabling (56790). But why go to all the trouble? 
|
|
| Author: | brickworx [ Wed Mar 26, 2008 7:39 pm ] |
| Post subject: | |
http://www.brickworx.com.au/imageviewer ... d=18&img=2 car has been cut up now... |
|
| Author: | AEG163job [ Thu Mar 27, 2008 7:51 am ] |
| Post subject: | |
Not a genuine Cooper, I hope............ |
|
| Author: | Harley [ Thu Mar 27, 2008 9:13 am ] |
| Post subject: | |
Nope, It's a rover disguised as an old cooper.
|
|
| Author: | frednutz&co [ Thu Mar 27, 2008 4:03 pm ] |
| Post subject: | |
we should not be cutting up cars any more only as a last resort |
|
| Author: | bnicho [ Fri Mar 28, 2008 10:46 am ] |
| Post subject: | |
frednutz&co wrote: we should not be cutting up cars any more only as a last resort
If it's made after 1988 it can't be imported into Aus legally as a whole car. So steve has to cut them up in Japan to bring the parts in. Better to get the parts and transfer them into another shell here than get nothing at all. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|