| ausmini https://www.ausmini.com/forums/ |
|
| Drive shafts https://www.ausmini.com/forums/viewtopic.php?f=2&t=4056 |
Page 1 of 1 |
| Author: | chasg [ Sun Jan 16, 2005 8:55 am ] |
| Post subject: | Drive shafts |
Can one fit the later model offset sphere type inner joints to early model drive shafts? That is are they interchangable cheers chasg |
|
| Author: | drmini in aust [ Sun Jan 16, 2005 1:49 pm ] |
| Post subject: | |
No. Shaft length, splines & machining de.tails are different. You can fit these shafts into your early C/Vs though. Also, note the diff output shafts are different. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|