ausmini
https://www.ausmini.com/forums/

How long is a cam?
https://www.ausmini.com/forums/viewtopic.php?f=2&t=41400		 Page 1 of 1
Author:  Wombat [ Thu Apr 24, 2008 6:07 pm ]
Post subject:  How long is a cam?
I'm looking at a 420mm post tube - will it fit?
Author:  Morris 1100 [ Thu Apr 24, 2008 6:34 pm ]
Post subject: 
362mm 8) (star drive 1100S cam)
Author:  Wombat [ Thu Apr 24, 2008 6:49 pm ]
Post subject: 
Thanks - one less post tube laying around the place :roll:
Author:  Morris 1100 [ Thu Apr 24, 2008 6:54 pm ]
Post subject: 
I would shove a sponge up each end to stop it flogging around and tape the ends carefully.
Author:  Mick [ Thu Apr 24, 2008 7:02 pm ]
Post subject: 
By the way, in case auspost tubes are measured in zeptometers,
it is 360 000 000 000 000 000 000 zeptometers long, which is 4.724 moots in the old scale 8)
Author:  drmini in aust [ Thu Apr 24, 2008 7:04 pm ]
Post subject: 
I just wrap them up good in bubblepak and stick em in a 3kg post satchel. :wink:
Author:  Wombat [ Thu Apr 24, 2008 8:36 pm ]
Post subject: 
Not posting it - just putting in the box of bits to go to GR for the block bore and cam bearing replacement - just looking for a little protection
Author:  gafmo [ Thu Apr 24, 2008 10:44 pm ]
Post subject: 
Bubble rap and Gaffa Tape :wink:
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/