I got 2 from Anthony at http://www.minisport.com.au/index.htm
cost about 70-80 each
| ausmini https://www.ausmini.com/forums/ |
|
| Australian sills..... https://www.ausmini.com/forums/viewtopic.php?f=2&t=41688 |
Page 1 of 1 |
| Author: | Blunder [ Sun May 04, 2008 8:23 pm ] |
| Post subject: | Australian sills..... |
Anyone know where you can get them? cheers |
|
| Author: | PimpMyMini [ Sun May 04, 2008 9:06 pm ] |
| Post subject: | |
I got 2 from Anthony at http://www.minisport.com.au/index.htm cost about 70-80 each
|
|
| Author: | simon k [ Sun May 04, 2008 9:07 pm ] |
| Post subject: | |
try A grade panels - he has them made, but they come just as a flat folded panel - IE without a hole cut for the jacking point and no vent pressings |
|
| Author: | mini-dunger [ Sun May 04, 2008 9:43 pm ] |
| Post subject: | |
just measure them and go to a sheetmetal place. they dont have dimples or anthing but at 40$ for 2 I dont really care 
|
|
| Author: | the bean [ Sun May 04, 2008 10:30 pm ] |
| Post subject: | |
i got my ones custom, by custom i mean made up |
|
| Author: | pristic [ Mon May 05, 2008 6:12 pm ] |
| Post subject: | |
They are NOT a straight part... if you look you will see that they are actually curved to match the body... for $70 odd, you should grab em Peter. |
|
| Author: | mini-dunger [ Mon May 05, 2008 7:07 pm ] |
| Post subject: | |
I did notice they were curved but the straight panels took on said curve once they were clamped in place.
|
|
| Author: | simon k [ Mon May 05, 2008 9:20 pm ] |
| Post subject: | |
mini-dunger wrote: I did notice they were curved but the straight panels took on said curve once they were clamped in place.
ditto... the ones from A grade are straight too, as are the UK ones I bought for my traveller - 1/2" an inch or whatever isn't hard to pull in over that length |
|
| Author: | Mick [ Mon May 05, 2008 10:08 pm ] |
| Post subject: | |
I have known people who folded them up using a high school sheet metal bender... Two folds and you're away! |
|
| Author: | frednutz&co [ Mon May 05, 2008 10:16 pm ] |
| Post subject: | |
many years ago i made some out of gal steel folded pop riveted on painted with black mastic on the inside and painted with black bitumen on the outside no one new i also fiberglassed the floor .not these days 
|
|
| Author: | britishvita [ Tue May 06, 2008 12:06 pm ] |
| Post subject: | |
Mick wrote: I have known people who folded them up using a high school sheet metal bender... Two folds and you're away!
I folded my own out of some galv sheet, pretty easy and its not too hard to put a slight curve in them. You can always curve them a bit more when fitting them
Don't seem to have any pics of them finished though |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|