ausmini
https://www.ausmini.com/forums/

KBS Coatings (Rust Seal)
https://www.ausmini.com/forums/viewtopic.php?f=2&t=41770		 Page 1 of 1
Author:  dannzhu [ Tue May 06, 2008 9:32 pm ]
Post subject:  KBS Coatings (Rust Seal)
Has anyone ever tried this product?
Made in Australia by KBS Coatings. "Supposedly" better than POR15?

Are these products actually stop rust?

Daniel
Author:  Rookiepilot [ Tue May 06, 2008 9:43 pm ]
Post subject: 
Yes. I have used both.

I've used KBS and POR15 and I can't tell the difference except for the price. KBS is a lot cheaper and Australian owned. They stop rust by excluding air.
Author:  dannzhu [ Tue May 06, 2008 9:51 pm ]
Post subject: 
So, how do you use it?
Clean up a panel till it's bare metal, then cover with KBS or POR, then prep for paint?

Daniel
Author:  gafmo [ Tue May 06, 2008 10:11 pm ]
Post subject: 
I have been useing POR15...so I'll give this one ago now..just wish they had a Clear also



dannzhu her you go
http://www.kbs-coatings.com.au/3-Step-System.asp
Author:  dannzhu [ Tue May 06, 2008 10:35 pm ]
Post subject: 
gafmo wrote:
I have been useing POR15...so I'll give this one ago now..just wish they had a Clear also
dannzhu her you go
http://www.kbs-coatings.com.au/3-Step-System.asp


Yeah, I read that bit...
I'm just not sure what happens next.
After the seal, the surface is prepped up for paint right?
But prepping involves sanding as well right?
Doesn't it remove the seal?

Daniel
Author:  dbr11k [ Tue May 06, 2008 10:39 pm ]
Post subject: 
i thought you had to wipe it with metho after the application
Author:  Wombat [ Wed May 07, 2008 8:53 am ]
Post subject: 
gafmo wrote:
I have been useing POR15...so I'll give this one ago now..just wish they had a Clear also


Clear is between white and silver in the colour chart :wink:
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/