| ausmini https://www.ausmini.com/forums/ |
|
| Unimig 175 inverter https://www.ausmini.com/forums/viewtopic.php?f=2&t=41873 |
Page 1 of 1 |
| Author: | jasonf [ Sat May 10, 2008 11:26 am ] |
| Post subject: | Unimig 175 inverter |
Looking at purchasing a mig and was looking at a Toolex 180 or transmig 200, the guy at my local then recommended the Unimig 175 mig/stick, a little more expensive (around the $1250, country town prices  ) but includes a few bits and pieces including auto darkening mask....
Heres a link to it... http://unimig.com.au/175mig.html Does anyone have one of these or used one, would appreciate a bit of feedback on these before I make a decision.... Cheers |
|
| Author: | mini-dunger [ Sat May 10, 2008 12:15 pm ] |
| Post subject: | |
I have used one and they are ok. As far as the helmets go.....its a bit of a grey area really. I use a old fashioned one. I use a fastglass at work but my eyes hurt sometimes. The helmets at work cost about $300 so if you buy this one you are potentially paying $300 you dont have too. I have a toolex 170amp and it goes and goes and goes. I bet the crap out of it regularly and its been great near on 5 years old now 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|