sounds like your 1275 is an A+ motor, they have a different drive dog, and the clamping method is different- they have 1 bolt and a finger clamp.
Like this-
| ausmini https://www.ausmini.com/forums/ |
|
| distributor spindle size https://www.ausmini.com/forums/viewtopic.php?f=2&t=42509 |
Page 1 of 1 |
| Author: | Ziegech [ Thu May 29, 2008 8:45 pm ] |
| Post subject: | distributor spindle size |
i just pulled my 1100 hundred apart and pulled the spindle out of the engine and realized it doesnt fit in my 1275 where there different sizes? the distributor fits like a glove in the engine but it should have the piece that locks the spindle in first that the distributor fits like a glove into if u get me. |
|
| Author: | drmini in aust [ Thu May 29, 2008 8:46 pm ] |
| Post subject: | |
sounds like your 1275 is an A+ motor, they have a different drive dog, and the clamping method is different- they have 1 bolt and a finger clamp. Like this-
|
|
| Author: | Ziegech [ Thu May 29, 2008 8:54 pm ] |
| Post subject: | |
yeah it is a A+ out of an MG metro turbo thanks for that doc. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|