| ausmini https://www.ausmini.com/forums/ |
|
| dashpot damper https://www.ausmini.com/forums/viewtopic.php?f=2&t=42912 |
Page 1 of 1 |
| Author: | maskilla [ Fri Jun 13, 2008 8:06 am ] |
| Post subject: | dashpot damper |
I have a an hif carb and noticed while topping up the dashpot oil that the damper rod swivels around on the cap but is not loose. I read on one site new SU plastic capped dampers have a ball socket in the cap which allows the rod to be self aligning. Is that right? Just curious. 
|
|
| Author: | poeee [ Fri Jun 13, 2008 9:15 am ] |
| Post subject: | |
I'm not SU expert but I would say it's completely fine unless it has up and down movement. |
|
| Author: | gafmo [ Fri Jun 13, 2008 8:37 pm ] |
| Post subject: | |
just pulled my HIF44 oil damper rod out and it does swivel |
|
| Author: | maskilla [ Fri Jun 13, 2008 9:30 pm ] |
| Post subject: | |
thanks! 
Guess thats why it has a bigger bulge on the cap rather than low profile flat one.?! To allow for some ball fitting type deal. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|