ausmini
https://www.ausmini.com/forums/

Water Sender Thread - Clubman
https://www.ausmini.com/forums/viewtopic.php?f=2&t=43122		 Page 1 of 1
Author:  lilmatti_69 [ Thu Jun 19, 2008 2:17 pm ]
Post subject:  Water Sender Thread - Clubman
Hi i was just wondering what the thread size is for the water sender in a late clubman head. I need a adapter for my speco temp gauge and i was told to get 544-42 5/8"unf x 18mm-1.5 but it was way to big. I emailed speco and these are the available adapters:
544-41 5/8"unf x 16mm-1.5
544-42 5/8"unf x 18mm-1.5
544-43 5/8"unf x 1/2"npt
544-44 5/8"unf x 3/8"npt
544-45 5/8"unf x 5/8"unf

Which one will i need?

Also the sender doesnt go all the way in the hole? Will i be able to still use it? Has anyone used this gauge on a late clubman?

Image

Cheers
Author:  Mick [ Thu Jun 19, 2008 6:08 pm ]
Post subject: 
The Omnipotent and all knowing Drmini in aust wrote:
The temp sender in head is either 5/8-16 (UNS bastard thread) or 5/8-18 UNF (depending who you talk to).
All I can say is, a 5/8-18 UNF tap cleans it out properly without removing metal so IMO it's close enough. AND, you can buy them... Wink


From a while back...
Author:  lilmatti_69 [ Thu Jun 19, 2008 6:21 pm ]
Post subject: 
I tried 5/8"unf x 18mm-1.5, and it was to big.
Author:  Wombat [ Thu Jun 19, 2008 6:29 pm ]
Post subject: 
When you say too big - would it screw in or jamb up - the Doc said to run a tap through first
Author:  lilmatti_69 [ Thu Jun 19, 2008 6:37 pm ]
Post subject: 
I cant even screw it in, it doesn't fit in the hole at all.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/