| ausmini https://www.ausmini.com/forums/ |
|
| Common wall thickness for headers https://www.ausmini.com/forums/viewtopic.php?f=2&t=43128 |
Page 1 of 1 |
| Author: | wyan [ Thu Jun 19, 2008 5:02 pm ] |
| Post subject: | Common wall thickness for headers |
Hello hello, I was wondering what wall thickness most mini headers are? I know it will vary quite abit, brands, diameter, quality etc. Myn are perry (not my choice but came with them) Im not sure of the diameter yet as I can find my damn verniers. Cheers |
|
| Author: | drmini in aust [ Thu Jun 19, 2008 7:25 pm ] |
| Post subject: | |
1.6mm (1/16") thick. Exhaust tubing goes up in 1/8" increments, measured on the outside diameter. |
|
| Author: | Mick [ Thu Jun 19, 2008 7:26 pm ] |
| Post subject: | |
Or do you mean pipe diameter?? |
|
| Author: | wyan [ Thu Jun 19, 2008 8:30 pm ] |
| Post subject: | |
cool, thanks doc Cheers |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|