Transmission case bolts (5/16" UNC) 6 lb/ft.
According to 2 of my manuals (including Leyland black book).
Sounds a bit low to me, I probably use 15 or so.. and if no locktabs handy I Loctite them with 262
| ausmini https://www.ausmini.com/forums/ |
|
| Third motion bearing retainer bolt torque setting? https://www.ausmini.com/forums/viewtopic.php?f=2&t=43163 |
Page 1 of 1 |
| Author: | Mick [ Fri Jun 20, 2008 7:41 pm ] |
| Post subject: | Third motion bearing retainer bolt torque setting? |
Can anyone tell me what I should be tightening the third motion retainer bolts up to? I can't seem to find it in the workshop manual...I took a guess at 30lbs but it would seem too much for the ally case I would think.. cheers |
|
| Author: | drmini in aust [ Fri Jun 20, 2008 7:50 pm ] |
| Post subject: | |
Transmission case bolts (5/16" UNC) 6 lb/ft. According to 2 of my manuals (including Leyland black book). Sounds a bit low to me, I probably use 15 or so.. and if no locktabs handy I Loctite them with 262
|
|
| Author: | Mick [ Fri Jun 20, 2008 7:57 pm ] |
| Post subject: | |
6lbs! Hardly seems worth getting the torque wrench out of it's case... But 15 lbs it is... thanks doc. |
|
| Author: | justminis [ Fri Jun 20, 2008 8:04 pm ] |
| Post subject: | |
My manual says 13ft lbs, so 15 will be fine 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|