Yeah a 3.44 is a good idea. 1098 has no trouble pulling it. Many 998 Clubbies ran a 3.44 too.
| ausmini https://www.ausmini.com/forums/ |
|
| Gearbox question https://www.ausmini.com/forums/viewtopic.php?f=2&t=4318 |
Page 1 of 1 |
| Author: | Drekkus [ Wed Jan 26, 2005 3:39 pm ] |
| Post subject: | Gearbox question |
Hopefully in the next few weeks I'll get to start pulling apart the K gearbox I'm going to use to replace the Deluxe box currently on the 1100 engine. I have a spare 3.44 diff.Is it worthwhile putting that in inplace of the 3.76 that currently in it. At the moment it just seems to be reving a bit too hard for my liking once you get up to 80kph. |
|
| Author: | drmini in aust [ Wed Jan 26, 2005 3:59 pm ] |
| Post subject: | |
Yeah a 3.44 is a good idea. 1098 has no trouble pulling it. Many 998 Clubbies ran a 3.44 too.
|
|
| Author: | poeee [ Wed Jan 26, 2005 4:38 pm ] |
| Post subject: | |
Wat sorta RPM does a 3.44 pull at 100km/h? |
|
| Author: | Mini Mad [ Wed Jan 26, 2005 4:44 pm ] |
| Post subject: | |
On my smiths (read 'jumpy') tacho in top it's about 4k... Personally I think it could run an even taller diff. I think makka was telling me about his old clubby and something like 160km/h @ some insanely low rpm 
|
|
| Author: | drmini in aust [ Wed Jan 26, 2005 6:02 pm ] |
| Post subject: | |
poeee wrote: Wat sorta RPM does a 3.44 pull at 100km/h?
16.05/16.1mph/1000 rpm with 10" wheels, depending which book you read. I make it about 4,000 at 100kmh in mine, as Josh says. So at 110? on the freeway I sit on 4,400. Haven't been pinged yet! (where's me bit o' wood..)
|
|
| Author: | min13k [ Wed Jan 26, 2005 6:06 pm ] |
| Post subject: | |
yeah but josh mine is a 2.???? extreamly low makka |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|