tight but not too tight
many threads on this forum covering ball joints. Check them out.
| ausmini https://www.ausmini.com/forums/ |
|
| ball joints https://www.ausmini.com/forums/viewtopic.php?f=2&t=44156 |
Page 1 of 1 |
| Author: | the vanman [ Wed Jul 23, 2008 9:17 pm ] |
| Post subject: | ball joints |
how do tight shoud the ball joints be when you ajust them? |
|
| Author: | AEG163job [ Thu Jul 24, 2008 9:12 am ] |
| Post subject: | |
tight but not too tight
many threads on this forum covering ball joints. Check them out.
|
|
| Author: | 1018cc [ Thu Jul 24, 2008 9:33 am ] |
| Post subject: | |
Here is a quote from the doc from this thread. drmini in aust wrote: Bfeboi wrote: but how should the ball joint feel when fully assembled?? cos im an apprentice the ball joints on the european cars i work on are tight when new but roll around smooth later. does it flow smooth or a bit notchy? When torqued up to 72 lb/ft, you should just be able to move it by hand. it will be a bit notchy. If you have a search you will be able to find plenty more threads. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|