does anybody know the size of the rear brake bleeder valve? I cant find a spanner to fit.
| ausmini https://www.ausmini.com/forums/ |
|
| Rear brake bleeder https://www.ausmini.com/forums/viewtopic.php?f=2&t=45543 |
Page 1 of 1 |
| Author: | Blokeinamoke [ Sun Sep 07, 2008 5:13 pm ] |
| Post subject: | Rear brake bleeder |
does anybody know the size of the rear brake bleeder valve? I cant find a spanner to fit.
|
|
| Author: | 1310/71 [ Sun Sep 07, 2008 5:15 pm ] |
| Post subject: | |
Vicegrips 
KB |
|
| Author: | Morris 1100 [ Sun Sep 07, 2008 6:18 pm ] |
| Post subject: | |
Depending on where and when it was made it could be 1/4", 5/16" or 8mm. 
|
|
| Author: | Blokeinamoke [ Sun Sep 07, 2008 6:20 pm ] |
| Post subject: | |
Morris 1100 wrote: Depending on where and when it was made it could be 1/4", 5/16" or 8mm.
1/4" was too big, 5/16" too small, so I suppose that leaves 8mm |
|
| Author: | Mister White Keys [ Sun Sep 07, 2008 8:19 pm ] |
| Post subject: | |
I've found they're usually either 8mm or 7mm. Most replacement rear cylinders are 7mm hex bleed screws. I've been doing quite a few brake jobs lately
|
|
| Author: | Beanie [ Sun Sep 07, 2008 9:03 pm ] |
| Post subject: | |
Yep go 7 and if that fails go the mighty vice grips |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|