195/45R13 Dunlop SP 9000's - fat and sticky (sounds just like my women - not!!!)
| ausmini https://www.ausmini.com/forums/ |
|
| tyre size on 14 (or even 14 inch) rim https://www.ausmini.com/forums/viewtopic.php?f=2&t=45653 |
Page 1 of 1 |
| Author: | ausminis4u [ Wed Sep 10, 2008 5:45 pm ] |
| Post subject: | tyre size on 14 (or even 14 inch) rim |
heey guys im looking at getting either 13 or 14 inch rims and would like to know what size tyres everyone is running, the rims will either be 5.5 or 6 inches wide. thanks, Ben. |
|
| Author: | Gordo [ Wed Sep 10, 2008 6:38 pm ] |
| Post subject: | |
I am running 175/50/13 on my 13 x7's but im not happy with the coverage on the rim (the rim sticks out further than the tyre). But on 5.5 or 6 wide they should be fine... |
|
| Author: | awdmoke [ Wed Sep 10, 2008 6:44 pm ] |
| Post subject: | |
I'm also running 175/50R13s on 13x7 rims. You would need VERY low profile 14s to keep to the same rolling diameter. I actually like the look (and handling) of the Yoko 032R 175s on the 7" wide rim (not that I had a choice). Check your tyre availability before you commit to any rims. |
|
| Author: | Archangel007 [ Wed Sep 10, 2008 9:16 pm ] |
| Post subject: | |
195/45R13 Dunlop SP 9000's - fat and sticky (sounds just like my women - not!!!)
|
|
| Author: | mad-mk1 [ Thu Sep 11, 2008 12:06 am ] |
| Post subject: | |
14s definentally not practical, tyres are an absolute pain to get. mine came from japan, no where in australia had anything that would fit, 14s are a tight fit, had to trim the rear subframe to fit, and im running step drums and inch and 3/4 spacers on the rear with 14x6 rims. |
|
| Author: | Harley [ Thu Sep 11, 2008 8:50 am ] |
| Post subject: | |
These 14s wouldn't be for a certain ungly miniature scooby-doo would they? Just go for 17s and be done. 
|
|
| Author: | ausminis4u [ Thu Sep 11, 2008 9:11 am ] |
| Post subject: | |
Harley wrote: These 14s wouldn't be for a certain ungly miniature scooby-doo would they?
Just go for 17s and be done. possibly, i have been looking atthe fiori in comparison to the mini inner guards and they are very similar in sizes. so i was thinking of basing my wheel calculations on a mini. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|