ausmini
https://www.ausmini.com/forums/

sc12 parts
https://www.ausmini.com/forums/viewtopic.php?f=2&t=45915		 Page 1 of 1
Author:  the vanman [ Thu Sep 18, 2008 9:53 pm ]
Post subject:  sc12 parts
hi all i picked i up a sc12 or sc14 at a swapmeet the other day but it is missing the pully setup, so i need the whole lot the middle bit that goes onto the shaft and a pully to run around 6psi.
are there any markings on the sc14 and can anyone tell me if the pullys are the same on both?
thanks gary
Author:  gafmo [ Thu Sep 18, 2008 10:04 pm ]
Post subject:  Re: sc12 parts
the vanman wrote:
are there any markings on the sc14
gary


Hi ya Gary the Sc14 has a Dip stik which is yellow
top right
Image
Author:  the vanman [ Tue Sep 23, 2008 9:32 am ]
Post subject: 
thanks i have a sc12 then.
Author:  slinkey inc [ Tue Sep 23, 2008 12:44 pm ]
Post subject: 
SC12 should be clearly embossed on the body on the supercharger.
Author:  69elf [ Tue Sep 23, 2008 7:53 pm ]
Post subject: 
My SC12 has a yellow dipstick so you can't use that to distinguish between SC12 and SC14. It does have SC12 cast on to the body.

I was told the other day that the SC12 has a restrictor in it which if you remove will give about 16psi instead of the standard 7psi.
Author:  gafmo [ Tue Sep 23, 2008 8:30 pm ]
Post subject: 
Yep I was wrong :roll:
Here's a handy link for you all 1/2 way down the Page
http://www.autospeed.com/A_110294/cms/article.html
Author:  the vanman [ Mon Oct 13, 2008 8:43 pm ]
Post subject: 
mine has a alloy dipstick the same as the charger.
Author:  the vanman [ Mon Oct 13, 2008 8:45 pm ]
Post subject: 
but there is nothing on it at all that says what it is.
Author:  gafmo [ Mon Oct 13, 2008 9:00 pm ]
Post subject: 
Note the differances between the brackets

SC12

Image

sc14
Image
Author:  the vanman [ Mon Oct 20, 2008 11:37 pm ]
Post subject: 
that helps, thanks i have a sc14.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/