| ausmini https://www.ausmini.com/forums/ |
|
| diff bearings https://www.ausmini.com/forums/viewtopic.php?f=2&t=46090 |
Page 1 of 1 |
| Author: | Goldbrocade_62 [ Wed Sep 24, 2008 6:43 pm ] |
| Post subject: | diff bearings |
Just bought new diff bearings as old ones are stuffed,they are different to the origonial ones will they be ok or pull another diff and use good secondhand ones |
|
| Author: | drmini in aust [ Wed Sep 24, 2008 7:30 pm ] |
| Post subject: | |
The new ones are angular contact ball type not deep groove, they are marked `thrust' on one side, this goes outwards. They fit the same, but note preload when shimmed should be .005", not .001" according to the old book. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|