Yes, just simply undo the engine steady bars , tilt the engine forward a little & Bob`s your Aunty,,, easy-peasy
| ausmini https://www.ausmini.com/forums/ |
|
| Extractor 'insertion' https://www.ausmini.com/forums/viewtopic.php?f=2&t=46625 |
Page 1 of 1 |
| Author: | mollymoke [ Mon Oct 13, 2008 3:37 pm ] |
| Post subject: | Extractor 'insertion' |
Hi all, I have tried to wriggle the new extractors into my roundy van, I just can't seem to get them down between the fire-wall and engine. Apart from undo the engine steady and tilt the engine, is there a simple trick? They are 'Cooper S' ManiFlow 3,2,1 pipes (so not the biggest ones either!). Suggestions? |
|
| Author: | TheMiniMan [ Mon Oct 13, 2008 3:45 pm ] |
| Post subject: | |
Yes, just simply undo the engine steady bars , tilt the engine forward a little & Bob`s your Aunty,,, easy-peasy
|
|
| Author: | Davo111 [ Mon Oct 13, 2008 4:12 pm ] |
| Post subject: | extractors |
wouldn't they fit easier from underneath 
|
|
| Author: | doogie [ Mon Oct 13, 2008 5:44 pm ] |
| Post subject: | Re: extractors |
Davo111 wrote: wouldn't they fit easier from underneath
No |
|
| Author: | Davo111 [ Mon Oct 13, 2008 6:54 pm ] |
| Post subject: | |
why |
|
| Author: | Mick [ Mon Oct 13, 2008 7:01 pm ] |
| Post subject: | |
Top is wider than the bottom, so they won't really wriggle through very easyily. |
|
| Author: | mollymoke [ Tue Oct 14, 2008 9:12 am ] |
| Post subject: | Extractors |
Thanks for the advice, will get them in soon. And Davo111, the answer is no, all those tubes are not going to fit from the bottom up! |
|
| Author: | Lillee [ Tue Oct 14, 2008 1:54 pm ] |
| Post subject: | |
Easier thing would be to lift the whole engine out and put the extractors on then lower it back in! 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|