ausmini
https://www.ausmini.com/forums/

How do I remove trumpets from rubber cones?
https://www.ausmini.com/forums/viewtopic.php?f=2&t=46974		 Page 1 of 1
Author:  Baxters850 [ Sat Oct 25, 2008 5:33 pm ]
Post subject:  How do I remove trumpets from rubber cones?
Hiya
As the suject states
Do I just hit it with a BFH tho did try that but only broke the alloy trumpet.going to put Hi LOs in.

Any ideas would be great.maybe good for how to thread


cheers
Baxter
Author:  justincase42 [ Sat Oct 25, 2008 5:42 pm ]
Post subject: 
Brute force, I just stripped down a front subby today and smashed both trumpets trying to seperate them from the rubber cones.........BUGGER........replacing them with hilo's anyway but WD40.......
Author:  drmini in aust [ Sat Oct 25, 2008 5:43 pm ]
Post subject: 
Soak overnight with WD40.
Hit edge of trumpet down from rubber with a BFH and chisel, work your way around.
Author:  Baxters850 [ Sat Oct 25, 2008 6:18 pm ]
Post subject: 
thx guyz will give it ago
Author:  Bubbacluby [ Sat Oct 25, 2008 8:08 pm ]
Post subject: 
do you mean remove the knuckle joint from the trumpet??

I got a big screw driver and put it in the centre of th trumpet and then belted screwdriver with hammer and freed the knuckle

I never had a problem with removing donut from trumpet
Author:  Kennomini [ Sat Oct 25, 2008 9:41 pm ]
Post subject: 
Like Doc said for the donut end soak it in WD40 and use a chisel or a flat screwdriver to work them apart. With the knuckles I sprayed the WD40 down the trumpet and let that soak for a night then I used a piece of steel rod with one end on the ground I slammed the trumpet down over it until the knuckle comes out the top.
WD40 is your friend :wink:
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/