Got my backing plates for the Honda disc conversion. Real good job - laser cut by the looks. 5/16" plate steel More than happy with the price Won't say who or how much - he's on this board so if he wants to advertise the fact he can
| ausmini https://www.ausmini.com/forums/ |
|
| Honda Discs one step closer https://www.ausmini.com/forums/viewtopic.php?f=2&t=4702 |
Page 1 of 1 |
| Author: | Wombat [ Thu Feb 10, 2005 1:50 pm ] |
| Post subject: | Honda Discs one step closer |
Got my backing plates for the Honda disc conversion. Real good job - laser cut by the looks. 5/16" plate steel More than happy with the price Won't say who or how much - he's on this board so if he wants to advertise the fact he can
|
|
| Author: | J_A_M [ Thu Feb 10, 2005 1:57 pm ] |
| Post subject: | |
oooohhhhh.....secrets..... Are you running 12's? |
|
| Author: | Wombat [ Thu Feb 10, 2005 2:13 pm ] |
| Post subject: | |
Ideally I'd like to run 10" - keeping it looking MKI as much as poss Depends if I can find an engineer to agree to turning the discs down |
|
| Author: | J_A_M [ Thu Feb 10, 2005 2:19 pm ] |
| Post subject: | |
hmmm...I thought the plates are different from 10's to 12's. The caliper sits further out from the centre of the hub when mounting Honda discs at full outer diameter (9 inch). 
|
|
| Author: | Wombat [ Thu Feb 10, 2005 2:22 pm ] |
| Post subject: | |
 I'll need to check that
|
|
| Author: | J_A_M [ Thu Feb 10, 2005 2:29 pm ] |
| Post subject: | |
sorry to be the bearer of that news.... |
|
| Author: | drmini in aust [ Thu Feb 10, 2005 6:30 pm ] |
| Post subject: | |
Wombat, Just need to redrill the caliper mount holes 14mm towards rear of car. ps. I know where you got the backing plates (no, not me) and how much.. but my lips are sealed! 
|
|
| Author: | Wombat [ Thu Feb 10, 2005 9:08 pm ] |
| Post subject: | |
)(*$(*&(&^$%#@()$)(*$@&^*@!%#^%^( I'VE GOT THE WRONG CALIPERS 
They're too bleeding big the mounting holes are too wide - back to square one - at least I have the backing plates 
|
|
| Author: | drmini in aust [ Thu Feb 10, 2005 9:28 pm ] |
| Post subject: | |
Wombat wrote: )(*$(*&(&^$%#@()$)(*$@&^*@!%#^%^(
I'VE GOT THE WRONG CALIPERS They're too bleeding big the mounting holes are too wide - back to square one - at least I have the backing plates Civics were 140mm bolt spacing, early Citys 110mm...
|
|
| Author: | ausminis4u [ Fri Feb 11, 2005 11:38 am ] |
| Post subject: | |
i bet i can guess who from, but with 110mm spacing, i will be getting my own made |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|