| ausmini https://www.ausmini.com/forums/ |
|
| 4 pot turbo cailper bolt torque https://www.ausmini.com/forums/viewtopic.php?f=2&t=47348 |
Page 1 of 1 |
| Author: | volkmini [ Fri Nov 07, 2008 6:35 pm ] |
| Post subject: | 4 pot turbo cailper bolt torque |
hi, can someone please give me the torque on the 4 bolts that hold the two halves of the cailper together. the manual says 56nm but that seems way to high. thanks |
|
| Author: | BALLISTIC [ Sun Nov 09, 2008 10:26 am ] |
| Post subject: | Re: 4 pot turbo cailper bolt torque |
volkmini wrote: hi, can someone please give me the torque on the 4 bolts that hold the two halves of the cailper together. the manual says 56nm but that seems way to high. thanks
Check the torque settings in lb's you'll find its not that high. |
|
| Author: | Harley [ Sun Nov 09, 2008 10:47 am ] |
| Post subject: | |
Have a read through this: http://www.ausmini.com/forums/viewtopic.php?t=14098 |
|
| Author: | clubmn [ Sun Nov 09, 2008 11:08 am ] |
| Post subject: | J |
tight.. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|