lilmatti_69 wrote:
Mine aren't huge dents, about 1/2-1 inch in diameter, and theres no creases. Will it ruin the paint in any way?
not any more than using a hammer
| ausmini https://www.ausmini.com/forums/ |
|
| Anyone try this? https://www.ausmini.com/forums/viewtopic.php?f=2&t=47638 |
Page 1 of 1 |
| Author: | lilmatti_69 [ Mon Nov 17, 2008 10:40 am ] |
| Post subject: | Anyone try this? |
Just wondering if anyone has tried this to remove small dings? http://au.youtube.com/watch?v=ItSWESEVOUA My dings are nowhere near that size though. Im abit skeptic but you never know. |
|
| Author: | simon k [ Mon Nov 17, 2008 11:14 am ] |
| Post subject: | |
he's lucky it was a nice clean dent.... it'd work for some dents, but not others - basically just the ones where there's been a bit of a push but no creasing |
|
| Author: | feralsprint [ Mon Nov 17, 2008 11:39 am ] |
| Post subject: | |
As Simon says it will work on smooth dents where the panel has been slightly stretched, you use a similar method to finish repairs when you straighten a dent out and the pasnel has been stretched, use a oxy or propane torch and heat the the panel and just wipe it with a wet sponge or rag or if it is stretched a lot you might have to give it a bit of work with a shrinking hammer before applying the water rag |
|
| Author: | lilmatti_69 [ Mon Nov 17, 2008 11:53 am ] |
| Post subject: | |
Mine aren't huge dents, about 1/2-1 inch in diameter, and theres no creases. Will it ruin the paint in any way? |
|
| Author: | simon k [ Mon Nov 17, 2008 11:58 am ] |
| Post subject: | |
lilmatti_69 wrote: Mine aren't huge dents, about 1/2-1 inch in diameter, and theres no creases. Will it ruin the paint in any way?
not any more than using a hammer
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|