Is there a "how to" or can anyone out there tell me how to tighten up the quarter vent latch? Any help would be much appreciated.

Tom B

It's worn out, you may need to replace the whole 1/4 window assembely.

Doogie

_________________
I won Hay once, here's the pic to prove it..


Hay, it's not about the car, it's not about the venue, it's about the people that come here. Peter Dwyer, Mayor of Hay NSW.

i have no idea, but would new rubber help the situation?

The Handle is made from zinc based diecast and is fairly soft compared to the pivot pin it is attached to, This often destroys the inside of the handle, However they sometimes can be repaired by putting a slightly larger brass pin in the handle and replacing the spring inside, It can be difficult to remove the existing brass pin, You will find the pin I am talking about is located on the bottom side of the handle