I sit the flange on the vice, hit stud with BFH...
You can fit the new ones the same way (oil them first) or press them in with a press, or use the vice and a couple of sockets.
Or, wind a wheel nut on the stud, with some washers underneath it.
| ausmini https://www.ausmini.com/forums/ |
|
| Rear S drums https://www.ausmini.com/forums/viewtopic.php?f=2&t=4844 |
Page 1 of 1 |
| Author: | Stuartminidlx [ Wed Feb 16, 2005 6:06 pm ] |
| Post subject: | Rear S drums |
i have some new rear S Drums with the 1 inch step on them i was just wondering if anyone has any tips on fitting them. i know i need longer studs and set screws. does anyone have any tips on knockin the studs out. i'm Fiiting them because i have discs and i need to even out the front and rear track. |
|
| Author: | drmini in aust [ Wed Feb 16, 2005 6:14 pm ] |
| Post subject: | |
I sit the flange on the vice, hit stud with BFH...
You can fit the new ones the same way (oil them first) or press them in with a press, or use the vice and a couple of sockets.
Or, wind a wheel nut on the stud, with some washers underneath it. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|