| ausmini https://www.ausmini.com/forums/ |
|
| boss kit https://www.ausmini.com/forums/viewtopic.php?f=2&t=48735 |
Page 1 of 1 |
| Author: | lh.67.mm [ Sat Dec 27, 2008 3:47 pm ] |
| Post subject: | boss kit |
where did you get yours? and what sort do you get? anyone know one to suit 77 clubman |
|
| Author: | drmini in aust [ Sat Dec 27, 2008 6:49 pm ] |
| Post subject: | |
All Oz Minis have the same spline on the steering column shaft. But, aftermarket wheels are not all the same. I have a SAAS hub and a MotaLita one, they each fit their own brand wheels. I believe an AutoTechnica hub has a few different hole patterns in it, to suit various wheels. I would not buy a wheel without sussing out a hub to suit it first. 
|
|
| Author: | Convertible Mini [ Sat Dec 27, 2008 7:51 pm ] |
| Post subject: | Boss Kits |
I have found some Mazda older cars had the same spilne config as a Mini. All you will need is machine the base to fit over steering column cover. I have done a couple like that on my lathe. Cheaper than buying one for "A Mini" |
|
| Author: | drmini in aust [ Sat Dec 27, 2008 7:58 pm ] |
| Post subject: | |
I believe some Volvo ones are the same too. Dunno which model... but Lillee runs one.
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|