How is this for BMC quality control. This is what I found inside a engine block that I stripped down for a twincam conversion. The sand core that was left in block around the rear of No. 4 cylinder. I wonder if this engine had a cooling problem
| ausmini https://www.ausmini.com/forums/ |
|
| How's this for BMC quality control??? https://www.ausmini.com/forums/viewtopic.php?f=2&t=49116 |
Page 1 of 1 |
| Author: | david rosenthal [ Sun Jan 11, 2009 1:02 am ] |
| Post subject: | How's this for BMC quality control??? |
How is this for BMC quality control. This is what I found inside a engine block that I stripped down for a twincam conversion. The sand core that was left in block around the rear of No. 4 cylinder. I wonder if this engine had a cooling problem
|
|
| Author: | justminis [ Sun Jan 11, 2009 8:42 am ] |
| Post subject: | |
I've just done a rebuild on a Clubby GT engine and found the very same stuff. Owner said it wasn't overheating 
|
|
| Author: | mini-dunger [ Sun Jan 11, 2009 11:18 am ] |
| Post subject: | |
I had a conrod that was 15g heavier than all the others. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|