| ausmini https://www.ausmini.com/forums/ |
|
| SU DZ needle https://www.ausmini.com/forums/viewtopic.php?f=2&t=49185 |
Page 1 of 1 |
| Author: | clubmn [ Tue Jan 13, 2009 8:50 am ] |
| Post subject: | SU DZ needle |
I seem to have a few of these needles kickin around, Im assuming the DZ needle is a factory standard needle for 998??.... Maybe someone can help me im trying to select a needle for an 1100 with 295 cooper head, extractors and exhaust.. Trying to find a good starting point. single 1 1/2 su |
|
| Author: | BALLISTIC [ Tue Jan 13, 2009 9:12 am ] |
| Post subject: | |
If its got a mild cam, a little bit of head work etc start with an M needle for the single 1.5 su |
|
| Author: | clubmn [ Tue Jan 13, 2009 9:42 am ] |
| Post subject: | mm1275 |
BALLISTIC wrote: If its got a mild cam, a little bit of head work etc start with an M needle for the single 1.5 su
I thought i rembered puttin in M needles in my twin 1 1/4's... isnt that right... Might have some hear?? |
|
| Author: | 74snail [ Tue Jan 13, 2009 12:32 pm ] |
| Post subject: | In another thread |
In another thread we were discussing this, for a fixed needle HA, for a floating needle ADC both have the same profile and are slightly richer than the factory standard AN still 7,000 rpm again as recommended by Russell from MinisRus . |
|
| Author: | BALLISTIC [ Tue Jan 13, 2009 1:45 pm ] |
| Post subject: | Re: In another thread |
74snail wrote: In another thread we were discussing this, for a fixed needle HA, for a floating needle ADC both have the same profile and are slightly richer than the factory standard AN still 7,000 rpm again as recommended by Russell from MinisRus .
The DZ fixed needle was std in stock 998 with 1.5" carbs from memory in leyland minis. Scott from Minitopia reccommends as a good starting point "M" needle/s for a mildly tuned engine but the only way you are going to find the best "set up" for any carb/engine is to get it on a rolling road/Dyno. |
|
| Author: | Morris 1100 [ Tue Jan 13, 2009 4:05 pm ] |
| Post subject: | |
The DZ was the stock needle for the 1275 Morris 1100S. |
|
| Author: | clubmn [ Tue Jan 13, 2009 4:53 pm ] |
| Post subject: | jay |
Morris 1100 wrote: The DZ was the stock needle for the 1275 Morris 1100S.
i thought it would had been for a 998, or 1100s as i have about 4 1 1/2 carbs with them in it ... ok well seems like an allright place to start... |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|