my brother and i pulled my engine down and could someone tell me what the name of this bearing is called as it needs replacing....first picture ia where it is located and second is the bearing
| ausmini https://www.ausmini.com/forums/ |
|
| whats this bearing called??????? https://www.ausmini.com/forums/viewtopic.php?f=2&t=49735 |
Page 1 of 1 |
| Author: | yeehaa [ Fri Jan 30, 2009 9:56 am ] |
| Post subject: | whats this bearing called??????? |
my brother and i pulled my engine down and could someone tell me what the name of this bearing is called as it needs replacing....first picture ia where it is located and second is the bearing
|
|
| Author: | My_Mini_Rocks [ Fri Jan 30, 2009 10:06 am ] |
| Post subject: | |
That would be: 
http://www.minisport.com.au/prod448.htm |
|
| Author: | BALLISTIC [ Fri Jan 30, 2009 10:12 am ] |
| Post subject: | |
out rigger |
|
| Author: | yeehaa [ Fri Jan 30, 2009 10:23 am ] |
| Post subject: | |
thankyou |
|
| Author: | simon k [ Fri Jan 30, 2009 12:38 pm ] |
| Post subject: | |
you'll need to remove the outer race from the housing - put a bolt through a large washer and weld it in place, weld the washer to the outer race, then put something big over the top, and screw a nut onto the bolt to pull it out if you know what I mean... |
|
| Author: | aaron [ Fri Jan 30, 2009 12:45 pm ] |
| Post subject: | |
two big screw drivers to lever it up a little, then a bearing puller to take it the rest of the way. Simple. 
|
|
| Author: | Morris 1100 [ Fri Jan 30, 2009 4:49 pm ] |
| Post subject: | |
Heat the cover with the oxy and drop the cover face down on concrete. [/butcher mode] |
|
| Author: | BALLISTIC [ Sat Jan 31, 2009 1:26 am ] |
| Post subject: | |
 first pull out the circlip that holds the outter bearing race in or you will be there for a while   
As morris said but ut may take more than on drop or hit on the ground. |
|
| Author: | Convertible Mini [ Sat Jan 31, 2009 1:07 pm ] |
| Post subject: | Again |
The outer bearing cone can also be removed easily by running a weld on the inner face with an arc welder which causes it to shrink and it will fallout easy. |
|
| Author: | sports850 [ Sat Jan 31, 2009 1:14 pm ] |
| Post subject: | |
I am amazed with the forum lately , 6 months ago the same question would have returned a dozen posts saying "it's called rooted" or similar . Well done to everyone who's given good , clear advice . |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|