| ausmini https://www.ausmini.com/forums/ |
|
| Mini Rotisserie https://www.ausmini.com/forums/viewtopic.php?f=2&t=49860 |
Page 1 of 1 |
| Author: | adnams4ever [ Mon Feb 02, 2009 3:05 pm ] |
| Post subject: | Mini Rotisserie |
Hi All, Does anyone have any plans/drawings/information/photo's on how to build a Rotisserie suitable for a Mini? Your assistance would be very much appreciated. |
|
| Author: | Wombat [ Mon Feb 02, 2009 3:24 pm ] |
| Post subject: | |
Rotisserie |
|
| Author: | frednutz&co [ Mon Feb 02, 2009 5:08 pm ] |
| Post subject: | |
there was one for sale here in melb |
|
| Author: | miniDave [ Mon Feb 02, 2009 6:56 pm ] |
| Post subject: | |
|
|
|
| Author: | adnams4ever [ Tue Feb 03, 2009 6:32 am ] |
| Post subject: | |
Thanks miniDave, Looks fairly simple to build. How do you hold the Mini in place when you turn it etc? Thanks again. miniDave wrote: |
|
| Author: | adnams4ever [ Tue Feb 03, 2009 6:40 am ] |
| Post subject: | |
Thanks Wombat, Appreciate your help. Now I'll go & price up the steel. Cheers Wombat wrote:
|
|
| Author: | miniDave [ Tue Feb 03, 2009 9:32 pm ] |
| Post subject: | |
adnams4ever wrote: Thanks miniDave,
Looks fairly simple to build. How do you hold the Mini in place when you turn it etc? quote] After these photos were taken I put holes through each bracket on the body (of the blue square) then a hole through the pipe running down the centre to lock it level, lock it sideways and lock it upside down. Used piece of 10mm rod to lock into the holes. |
|
| Author: | adnams4ever [ Wed Feb 04, 2009 7:54 pm ] |
| Post subject: | |
Cheers, thanks again for your help. miniDave wrote: adnams4ever wrote: Thanks miniDave, Looks fairly simple to build. How do you hold the Mini in place when you turn it etc? quote] After these photos were taken I put holes through each bracket on the body (of the blue square) then a hole through the pipe running down the centre to lock it level, lock it sideways and lock it upside down. Used piece of 10mm rod to lock into the holes. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|