ausmini
https://www.ausmini.com/forums/

Front Door Pocket Cards
https://www.ausmini.com/forums/viewtopic.php?f=2&t=49947		 Page 1 of 2
Author:  Mick [ Wed Feb 04, 2009 4:59 pm ]
Post subject:  Front Door Pocket Cards
I'm looking for a relatively simple template.
If anyone has an old front wind up door pocket card lying around in a reasonable state, may I ask that they take a photo for me and measure it's overall length and width?

I'm making new ones, but am short of this template. It will be fairly easy, hence I only need a few measurements to finish it off.

This will be the last of the upholstery! Woo hoo!

Mick
Author:  TUCK3r [ Wed Feb 04, 2009 6:59 pm ]
Post subject: 
i got clubby ones if they are the same not sure.
Author:  Mick [ Wed Feb 04, 2009 7:50 pm ]
Post subject: 
I believe they are. It's a very simple design I believe, not prone to changes.
Author:  John Smidt [ Wed Feb 04, 2009 7:54 pm ]
Post subject: 
Some model Clubmans are different in that part of the trim folds upward along the pocket edge, they do fit but just thought I would point out the difference
Author:  Mick [ Wed Feb 04, 2009 8:25 pm ]
Post subject: 
Ok, doors I pulled apart had two piece. One is a piece of hessian backing under vinyl, and the rest I am missing
Author:  TUCK3r [ Wed Feb 04, 2009 9:04 pm ]
Post subject: 
mys a single piece and folds up as john explains. ill take photos tomorrow
Author:  drmini in aust [ Wed Feb 04, 2009 9:12 pm ]
Post subject: 
My old 1966 vintage ones were shrivelled up bits of red fibreboard and vinyl. I wanted black this time so took a couple out of my Clubby doors, a perfect fit. :D
Author:  Mick [ Wed Feb 04, 2009 9:43 pm ]
Post subject: 
Yep, anything will do...I will modify them, I just really want to get the general dimensions..
Author:  BALLISTIC [ Wed Feb 04, 2009 9:47 pm ]
Post subject: 
I'll have a look in the morning mick......if i have one come and get it. (im sure i do somewhere around here)
Author:  Mick [ Wed Feb 04, 2009 9:48 pm ]
Post subject: 
Thanks Scott, I have reason to visit that way as well. I need another meter of MG black :oops:
Author:  BALLISTIC [ Wed Feb 04, 2009 10:12 pm ]
Post subject: 
i shall let you know tomorrow mick.
Author:  BALLISTIC [ Thu Feb 05, 2009 10:10 am ]
Post subject: 
Mick its now the today of tomorrow........ :D guess what............
Author:  Mick [ Thu Feb 05, 2009 1:30 pm ]
Post subject: 
Wooo! Thanks Scott.
Author:  Wombat [ Thu Feb 05, 2009 2:09 pm ]
Post subject: 
If nothing turns up I'll draw you a templet and send it down
Author:  Mick [ Thu Feb 05, 2009 2:21 pm ]
Post subject: 
Thanks Wombat, all good now. I've got the template transferred onto the card now, all I need to do is cut it out and add the vinyl.
Page 1 of 2 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/