| ausmini https://www.ausmini.com/forums/ |
|
| Bore size. https://www.ausmini.com/forums/viewtopic.php?f=2&t=50119 |
Page 1 of 1 |
| Author: | Drekkus [ Mon Feb 09, 2009 3:31 pm ] |
| Post subject: | Bore size. |
I've just picked up a free mini K engine & gearbox.I've stripped the block back and am trying to work out the bore size.Rough measurement is 65.4mm.The pistons are marked +1.016. Would I be right in thinking its 40 thou over. |
|
| Author: | drmini in aust [ Mon Feb 09, 2009 3:47 pm ] |
| Post subject: | |
Yes except your measurement is slightly under. Stock bore is 64.59 so the bore should now measure about 65.6. |
|
| Author: | Drekkus [ Mon Feb 09, 2009 4:09 pm ] |
| Post subject: | |
drmini in aust wrote: Yes except your measurement is slightly under.
Stock bore is 64.59 so the bore should now measure about 65.6. Thanks.It was just a rough measurement as I was hoping the marking on the piston would give it.What I measured could have easily be 65.6. The bore, rings and bearings (apart from 1 cam bearing) all look in good condition not that I would be reusing them.I don't think this engine has seen a lot of use since its last rebore. It was part of a project that didn't go ahead.I also got the doors, bonnett ,grill and instrument cluster. A quick look at the gear box looks good too. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|