Could someone tell me if this a standard water pump or not.
The impellor is 52mm wide and 20mm deep.
The only numbers on it are 17.331.2, 17.244.8 and 13j020.
Any help would be great.
Cheers Pete
| ausmini https://www.ausmini.com/forums/ |
|
| Water Pump https://www.ausmini.com/forums/viewtopic.php?f=2&t=5014 |
Page 1 of 1 |
| Author: | EST-071 [ Wed Feb 23, 2005 11:22 am ] |
| Post subject: | Water Pump |
Could someone tell me if this a standard water pump or not. The impellor is 52mm wide and 20mm deep. The only numbers on it are 17.331.2, 17.244.8 and 13j020. Any help would be great. Cheers Pete
|
|
| Author: | ausminis4u [ Wed Feb 23, 2005 11:35 am ] |
| Post subject: | |
looks like a standard late model pump, i rather the cast impellor types as the pressed ones rust off alot quicker and float around in the cooling system. edit: i crossreferenced all the numbers on the karcraft catalogue, none matched up , here are their p/n GWP134 <A> WATER PUMP - MINI (HI CAPACITY) GWP132 <B> WATER PUMP - MINI (SMALL IMPELLOR) |
|
| Author: | dr trim [ Wed Feb 23, 2005 3:27 pm ] |
| Post subject: | |
i thought that was the high flow type? rather than the standard which is basically a star. inevitably im probably wrong 
|
|
| Author: | CLUBMAN [ Wed Feb 23, 2005 3:35 pm ] |
| Post subject: | |
looks to be the same as the one that came out of my thrash motor 
looked like a hi-flo one,but when i asked my boss,he just said it was a poofter one,so my guess is its late model one(seen a fue like that one come off rovers) |
|
| Author: | EST-071 [ Wed Feb 23, 2005 9:00 pm ] |
| Post subject: | |
ausminis4u wrote: i rather the cast impellor types as the pressed ones rust off alot quicker and float around in the cooling system.
That's got to be bad for it!!! 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|