John Smidt wrote:
Check, on some model dash boards the instruments screw to the back of the dash, This negates the use of the bracket
As John said
| ausmini https://www.ausmini.com/forums/ |
|
| Clubby triple gauges https://www.ausmini.com/forums/viewtopic.php?f=2&t=50410 |
Page 1 of 1 |
| Author: | possum-16 [ Wed Feb 18, 2009 11:12 am ] |
| Post subject: | Clubby triple gauges |
Have put a 94 Rover wooden dash into my 73 Clubby. Looks and fits well except the gauges are recessed behind the dash. When you look at the dash you can see through between the dash and gauges. Question: Is it possible to move the gauges forward? Can you move gauges without moving bracket? How difficult? Will it effect the wiring? |
|
| Author: | John Smidt [ Wed Feb 18, 2009 2:13 pm ] |
| Post subject: | |
Check, on some model dash boards the instruments screw to the back of the dash, This negates the use of the bracket |
|
| Author: | possum-16 [ Sat Feb 21, 2009 2:17 pm ] |
| Post subject: | |
To Mini74: sorry I have tried to reply but it "times out" Pm me with your email and I will send photos. Gary |
|
| Author: | BALLISTIC [ Sat Feb 21, 2009 3:41 pm ] |
| Post subject: | |
John Smidt wrote: Check, on some model dash boards the instruments screw to the back of the dash, This negates the use of the bracket
As John said
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|