Can someone post the correct method of installing the side trim finisher on Cooper S.

I have the right clips from John (MiniKing), but read somewhere that you start at one end (which one)? and unroll the strip a certain direction (not sure), and use a hair dryer to warm the strip around the tight bends (makes sense).

Can someone put more detail on this so no stuff ups.


I did think they were pop riveted on, but after talking to John, he said NO the correct clips should hold both flare and finisher strip always in place.

Steve

_________________
"Boris" - '69 Cooper S Mk 2

You need to go to this thread,
http://www.ausmini.com/forums/viewtopic ... highlight=
I like my method best!
Dave

_________________

Thats the post I was looking for.

The straightening out approach (on the cloths line) seems the easiest.

I'll try that one.

Thank you

_________________
"Boris" - '69 Cooper S Mk 2