| ausmini https://www.ausmini.com/forums/ |
|
| Question: wheel arch side trim install https://www.ausmini.com/forums/viewtopic.php?f=2&t=50505 |
Page 1 of 1 |
| Author: | 4myego [ Sat Feb 21, 2009 7:59 am ] |
| Post subject: | Question: wheel arch side trim install |
Can someone post the correct method of installing the side trim finisher on Cooper S. I have the right clips from John (MiniKing), but read somewhere that you start at one end (which one)? and unroll the strip a certain direction (not sure), and use a hair dryer to warm the strip around the tight bends (makes sense). Can someone put more detail on this so no stuff ups. I did think they were pop riveted on, but after talking to John, he said NO the correct clips should hold both flare and finisher strip always in place. Steve |
|
| Author: | sitnlo62 [ Sat Feb 21, 2009 10:15 am ] |
| Post subject: | |
You need to go to this thread, http://www.ausmini.com/forums/viewtopic ... highlight= I like my method best! Dave |
|
| Author: | 4myego [ Sat Feb 21, 2009 3:51 pm ] |
| Post subject: | |
Thats the post I was looking for. The straightening out approach (on the cloths line) seems the easiest. I'll try that one. Thank you |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|