| ausmini https://www.ausmini.com/forums/ |
|
| Mildly pi$$ed off https://www.ausmini.com/forums/viewtopic.php?f=2&t=50805 |
Page 1 of 1 |
| Author: | Wombat [ Mon Mar 02, 2009 5:25 pm ] |
| Post subject: | Mildly pi$$ed off |
Been chasing around for 5/16" Bundy tube for new fuel line. After a bad experience with the local ABS dealer I've been avoiding them but after 1/2 hour on the phone this morning they were the only place that said they had any. After waiting 20 minutes while they tried to get the printer to print an invoice I walked out with my tube only to find when I get home it is 1/4" and the wall thickness is so thick the inside diameter is smaller that the one I'm trying to replace 
|
|
| Author: | Harley [ Mon Mar 02, 2009 5:28 pm ] |
| Post subject: | |
Just be thasnkful the inside diameter isnt bigger than the outside diameter! That messes with your head! 
|
|
| Author: | Mick [ Mon Mar 02, 2009 6:24 pm ] |
| Post subject: | |
Holy smoke....it must be high pressure hydraulic line (!?). |
|
| Author: | david rosenthal [ Tue Mar 03, 2009 1:27 am ] |
| Post subject: | |
Mick wrote: Holy smoke....it must be high pressure hydraulic line (!?).
injector fuel line |
|
| Author: | JC [ Tue Mar 03, 2009 8:32 am ] |
| Post subject: | |
How much do you need Wombat? I've some at home. |
|
| Author: | Wombat [ Tue Mar 03, 2009 8:50 am ] |
| Post subject: | |
I'm looking for 2.5 metres |
|
| Author: | Lillee [ Tue Mar 03, 2009 10:23 am ] |
| Post subject: | |
I got mine at Pirtek |
|
| Author: | Speed [ Tue Mar 03, 2009 11:18 am ] |
| Post subject: | |
Quote: I got mine at Pirtek
Pyrtek is where I'd go aswell. Good luck!!! |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|