They swing very freely - just tilting the arm and the quadrants find their own low point
| ausmini https://www.ausmini.com/forums/ |
|
| Handbrake quadrants need spaces on the rear trailing arms? https://www.ausmini.com/forums/viewtopic.php?f=2&t=50900 |
Page 1 of 1 |
| Author: | TUCK3r [ Thu Mar 05, 2009 6:41 pm ] |
| Post subject: | Handbrake quadrants need spaces on the rear trailing arms? |
i've just put my rear end together on the mini to realised that the quadrants don't pivot on the the trailing arm , it worked before i pulled it apart. now its back together the quadrants don't want to pivot on the trailing arm does any one have a pic of how the quadrant should be set to get a free pivoting action.i looked in the mini king catalouge and says it has spaces when i pulled it apart there where no spaces just a washer and a spring washer. Cheers TUCK3R |
|
| Author: | Mick [ Thu Mar 05, 2009 8:27 pm ] |
| Post subject: | |
Are they binding on the arm or are the bushes within the arm damaged? Have you put the quadrants in upside down? |
|
| Author: | Wombat [ Thu Mar 05, 2009 8:29 pm ] |
| Post subject: | |
|
They swing very freely - just tilting the arm and the quadrants find their own low point |
|
| Author: | TUCK3r [ Fri Mar 06, 2009 9:38 pm ] |
| Post subject: | |
thanks for the picture. i have the bolt going coming from the top. but that shouldnt make that much difference other than that i think i may have over tightened it? |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|