i have both crash covers.
now just wondering how do they sit in?
there is no holes for bolts so does it just glue in?
bit of tape haha
no really how do you put it in your old mini.
thanks for your help guys.
| ausmini https://www.ausmini.com/forums/ |
|
| rover switch panel.. in an older mini how do they fit. https://www.ausmini.com/forums/viewtopic.php?f=2&t=51170 |
Page 1 of 1 |
| Author: | NG [ Fri Mar 13, 2009 10:45 am ] |
| Post subject: | rover switch panel.. in an older mini how do they fit. |
i have both crash covers. now just wondering how do they sit in? there is no holes for bolts so does it just glue in? bit of tape haha
no really how do you put it in your old mini. thanks for your help guys. |
|
| Author: | jbeenz [ Fri Mar 13, 2009 4:00 pm ] |
| Post subject: | |
They have brackets that bolt to the choke and heater cables, and bring the whole panel out an inch or so, to sit in the paded lower dash rail. |
|
| Author: | NG [ Fri Mar 13, 2009 6:47 pm ] |
| Post subject: | |
where can i get these brackets? |
|
| Author: | Drekkus [ Fri Mar 13, 2009 7:59 pm ] |
| Post subject: | |
I have one in my car.There was a bit of stuffing around to get the bolts to line up in the original holes so I've only done one side so far.There should be a sort of bracket and bolt thingie where the heater and choke cables go through. If I remember rightly I ended up grounding out the existing bolt and replacing it with a slightly longer one. |
|
| Author: | NG [ Fri Mar 13, 2009 8:08 pm ] |
| Post subject: | |
ive got a rover heater.. im kinda lost i dont realy see any brackets. ive only got a choke cable no heater cable im going to buy one. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|