Need a reducer to take the probe for the temp sender for my new gauge. The adapter that came with it is 1/2" but the hole is 5/8" (I think) Is it NFC ?
Edit changed 3/8 to 5/8 - had a blond moment
| ausmini https://www.ausmini.com/forums/ |
|
| Temp sender thread size? https://www.ausmini.com/forums/viewtopic.php?f=2&t=52528 |
Page 1 of 1 |
| Author: | Wombat [ Sat Apr 25, 2009 8:37 pm ] |
| Post subject: | Temp sender thread size? |
Need a reducer to take the probe for the temp sender for my new gauge. The adapter that came with it is 1/2" but the hole is 5/8" (I think) Is it NFC ? Edit changed 3/8 to 5/8 - had a blond moment
|
|
| Author: | Mick [ Sat Apr 25, 2009 8:40 pm ] |
| Post subject: | |
drmini in aust wrote: OK...
The temp sender in head is either 5/8-16 (UNS bastard thread) or 5/8-18 UNF (depending who you talk to). All I can say is, a 5/8-18 UNF tap cleans it out properly without removing metal so IMO it's close enough. AND, you can buy them... |
|
| Author: | drmini in aust [ Sat Apr 25, 2009 8:41 pm ] |
| Post subject: | |
Nope it's not 3/8 NPT or BSP, it is 5/8-18 UNF. And to those who say noooo, it's 5/8-16 UNS bastard thread, I'll say a UNF tap screws right in and doesn't cut metal out. 
|
|
| Author: | Mick [ Sat Apr 25, 2009 8:44 pm ] |
| Post subject: | |
You forgot to say"and you can buy them" Doc... 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|