| ausmini https://www.ausmini.com/forums/ |
|
| Back on the Road https://www.ausmini.com/forums/viewtopic.php?f=2&t=53246 |
Page 1 of 1 |
| Author: | Drexxle [ Fri May 15, 2009 12:56 pm ] |
| Post subject: | Back on the Road |
Ok peeps, Getting back on the road after all the hassles  . So heading for Goondiwindi Tomorrow. St George on the Wednesday. Across the border into NSW on the Sunday.
So finally, maybe on the Saturday, BBQ somewhere in St George. Any mini peeps in Bourke, then im passing through in the following week. |
|
| Author: | Fiji [ Fri May 15, 2009 1:27 pm ] |
| Post subject: | |
good luck ,,, hope the journeys is hassel less |
|
| Author: | Drexxle [ Mon May 18, 2009 3:13 pm ] |
| Post subject: | |
made it to st george, ill have some pics of lots of stuff soon, and some text to go with it. I'll be in the area till sunday, then im heading for Lightning Ridge. Clutch has now got an oil leak, slipping and shuddering again 
But i have parts. 
Other than that, Bobs yer aunty. |
|
| Author: | Juno88 [ Mon May 18, 2009 3:17 pm ] |
| Post subject: | |
look forward to the pics. |
|
| Author: | Morris 1100 [ Mon May 18, 2009 5:58 pm ] |
| Post subject: | |
Drexxle wrote: made it to st george, ill have some pics of lots of stuff soon, and some text to go with it. I'll be in the area till sunday, then im heading for Lightning Ridge.
Clutch has now got an oil leak, slipping and shuddering again But i have parts. Other than that, Bobs yer aunty. You could squirt some CRC Brakleen into the clutch via the little timing mark hole and the starter hole (after removing the starter) This may slow the slipping down a little. Make sure the drain hole in the bottom of the clutch housing is not blocked. |
|
| Author: | Drexxle [ Wed May 20, 2009 3:06 pm ] |
| Post subject: | |
Thanks for the CRC tip 1100, its started to slip alot now. Rev it and it slips, once its been on road for 10 mins its fine, seems to dry out. http://www.googajoob.com/v3/index.php?m ... ticleid=26 some pics and some text. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|