| ausmini https://www.ausmini.com/forums/ |
|
| Fabricators https://www.ausmini.com/forums/viewtopic.php?f=2&t=53476 |
Page 1 of 1 |
| Author: | Booglie [ Fri May 22, 2009 9:31 am ] |
| Post subject: | Fabricators |
Does anyone know of a person/company in Brisbane that can make a mount for the crank position sensor of an EDIS system? |
|
| Author: | simon k [ Fri May 22, 2009 9:59 am ] |
| Post subject: | |
I made mine last weekend - not complicated at all.... anyone with a welder could knock one up for you. |
|
| Author: | Booglie [ Fri May 22, 2009 10:39 am ] |
| Post subject: | |
I'd have a go myself but my welding skill aren't that good, horrid infact. |
|
| Author: | simon k [ Fri May 22, 2009 11:08 am ] |
| Post subject: | |
I made mine to mount off the radiator end engine mount bracket, it's basically just a piece of flat steel with a 90* bend in it - the only welding it needed was a bracing gusset - make it yourself and take it to an exhaust shop, say "weld this right here" and they might charge $5 you for it.... |
|
| Author: | 92 [ Fri May 22, 2009 8:41 pm ] |
| Post subject: | |
http://www.ausmini.com/forums/viewtopic.php?t=51258&start=0 |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|