ausmini https://www.ausmini.com/forums/ |
|
Getting a manifold made up? https://www.ausmini.com/forums/viewtopic.php?f=2&t=53518 |
Page 1 of 1 |
Author: | mattsmadmini [ Sat May 23, 2009 12:05 pm ] |
Post subject: | Getting a manifold made up? |
Ive got sitting in my garage a nice set of CX500 38mm carbs waiting to go anywhere (not the bin!) id really like to be able to set them on a mini engine/head as something a little different (though someone on here has alread done so...) So just wondering if anyone has any ideas where to get a manifold made up? not that complicated, a 1.5" pipe, welded to bottom flange, then attach carbs with silicon tubing to manifold... Cheers, Matt |
Author: | david rosenthal [ Sat May 23, 2009 9:51 pm ] |
Post subject: | |
So you want a manifold to go with the head as well. OK twist my arm and give me a pic of the carby base and length overall of the carby. |
Author: | mattsmadmini [ Sun May 24, 2009 12:30 pm ] |
Post subject: | |
thanks David. Ok some dimensions, full length of it is just shy of 9 1/2". Between needles is just shy of 6 1/2" width from filter side to intake side is 4 1/2" ![]() ![]() ![]() ball is in your court... |
Author: | mattsmadmini [ Sun May 24, 2009 12:38 pm ] |
Post subject: | |
![]() thats them in situ... no real angle there... ![]() |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |