| ausmini https://www.ausmini.com/forums/ |
|
| Need: picture of brake line setup in engine bay https://www.ausmini.com/forums/viewtopic.php?f=2&t=53556 |
Page 1 of 1 |
| Author: | willy [ Sun May 24, 2009 6:59 pm ] |
| Post subject: | Need: picture of brake line setup in engine bay |
Right, its time to route my brake line. More specifically, the line that goes front to rear. I think, at this stage, I will be running a tandem setup. Will this make any difference in the way the line runs from front to rear? And secondly, I'm after some pics of how it is arranged. --- ie as it sneaks up behind the front subframe and to the master cylinder. Rear pics would be nice too. 
|
|
| Author: | gafmo [ Sun May 24, 2009 7:06 pm ] |
| Post subject: | |
Page two and Three http://www.ausmini.com/forums/viewtopic ... c&start=15 & Three & Four http://www.ausmini.com/forums/viewtopic ... c&start=30 |
|
| Author: | mickmini [ Mon May 25, 2009 1:02 am ] |
| Post subject: | |
Road car or race car willy? If race car, run it inside the car. Small hole with a grommet at each end to pass the line through. Makes it easy to fit, can't take it out on a ripple strip if you get a bit wayward. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|