The large bump stops used by the special tuning kits for hydrolastic cars....I believe these are actually MG parts originally? Am I right?
Does anyone know the MG part numbers?
| ausmini https://www.ausmini.com/forums/ |
|
| ST bump stops https://www.ausmini.com/forums/viewtopic.php?f=2&t=54388 |
Page 1 of 1 |
| Author: | Mick [ Thu Jun 18, 2009 8:05 pm ] |
| Post subject: | ST bump stops |
The large bump stops used by the special tuning kits for hydrolastic cars....I believe these are actually MG parts originally? Am I right? Does anyone know the MG part numbers?
|
|
| Author: | drmini in aust [ Thu Jun 18, 2009 8:07 pm ] |
| Post subject: | |
The rubber is an MGB rear bumpstop. Brackets are not. I would not fit them to the front unless you are building a rally car. They give too much height and positive camber. Fine on the rear... 
|
|
| Author: | Mick [ Thu Jun 18, 2009 8:35 pm ] |
| Post subject: | |
Thanks Doc, I split the pair I have fitted on the rear arms because I didn't roll the seam they bump into over when I put it together...I saw it, but forgot to do anything about it... All fixed now, MR rubber Mallet performs a very nice job of rolling them over a little
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|