ausmini
https://www.ausmini.com/forums/

Need door hinge parts!
https://www.ausmini.com/forums/viewtopic.php?f=2&t=54748		 Page 1 of 1
Author:  Harley [ Tue Jun 30, 2009 6:55 pm ]
Post subject:  Need door hinge parts!
I have this problem, when my car was painted the doors were re-assembled by some chump who didnt know what he was doing and the doors warped.

The car is back at the panel beaters again to get this fixed.
I need to obtain all the washers (big, small, tapered or flat) for a complete car.

Does anybody have a spare set or know where I can get some?
It would be a huge help!

I need other door parts too if anyone is dismantling.

Thanks.
:D
Author:  minifreak1 [ Wed Jul 01, 2009 6:11 am ]
Post subject: 
try northern minis.
i had to go there last week as for some reason the panel shop didnt put the nuts back on that hold the door hinge to the car???
and as they are a mini nut ya cant just go to bunnings to get them...size..1/4 i think but in a fine thred...he had heaps brand new.so i was happy....
im sure he will have what ya want...
so far to date i have been able to get all my hard to find parts from him..
just dont try to bargan him down on his prices as he will tell ya to get nodded...he hates it..
Author:  Harley [ Wed Jul 01, 2009 9:10 am ]
Post subject: 
Deos anyone have a photo of the bits I'm after?
I have no idea what they look like.
I may need to make some.
Author:  mini-dunger [ Wed Jul 01, 2009 9:17 am ]
Post subject: 
from memory its only the top ones that get the tapered washer. As far as other washers go I think its open for interpretation I used the biggest ones I could on the bottom to spread out the clamping forces so the doors didn't distort.

I could only find 1 of the tapered washers so I just cut some more out of an old rocker shaft.

as far as studs go go and buy some 1/4 unf bolts and cut the heads off..
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/