Are these the ones you are after?
If they are, I have a set here that have done about 6 months work.
Don't need them anymore, now have a SPI.
Make me an offer.
Cheers Pete
| ausmini https://www.ausmini.com/forums/ |
|
| Freeflow extractors - where from? https://www.ausmini.com/forums/viewtopic.php?f=2&t=54943 |
Page 1 of 1 |
| Author: | miniDave [ Tue Jul 07, 2009 9:22 pm ] |
| Post subject: | Freeflow extractors - where from? |
Tried Karcraft today but no Freeflow or any other extractors in stock (will try to ring Tim back tomorrow to double check). Any sugggestions on where else I might try? Want somewhere in Sydney so I can pick up (need to have car going this week). Need something that is going to work with rubber uni joints. Help, help, help |
|
| Author: | TheMiniMan [ Tue Jul 07, 2009 9:27 pm ] |
| Post subject: | |
John @ mini king??? |
|
| Author: | drmini in aust [ Tue Jul 07, 2009 9:59 pm ] |
| Post subject: | |
I like the Perry freeflow ones, if you can't fit an LCB. They are more robust than the Maniflow freeflows, of which I have seen a few crack at the top Y joint. Perry is now part of http://www.hmheaders.com.au/ |
|
| Author: | EST-071 [ Tue Jul 07, 2009 10:02 pm ] |
| Post subject: | |
Are these the ones you are after? If they are, I have a set here that have done about 6 months work. Don't need them anymore, now have a SPI. Make me an offer. Cheers Pete
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|